CQuartz SiC Pro Size
QUARTZ SiC is ready to continue where Tio2 left off! As the name would suggest, this new formula also includes SiC (Silicon Carbide) for additional resistance against chemicals! Not only that but CQUARTZ SiC greatly improves the ease of use, resistance to water (mineral) spots, and even amped up the gloss! Finally, the slickness will leave you thrilled with the finished product!
Type of Product: Coating
STEPS OF USE: Use only in good ambient lighting
- Wrap a 4" microfiber suede around the grey side of applicator block.
- Shake CQUARTZ.
- Slowly open bottle and drag one line of product down the applicator.
- Spread across paint in a criss cross pattern approximately 2 sq ft at a time depending on conditions.
- Buff off about 5 minutes later when you see a white haze begin to form. (3~15 minutes depends on conditions) - see additional tips below) using a CARPRO No Lint Ultra Towel 16" x 16".
- Be sure to remove all excess residue when wiping off.
- Switch out the 4" Suedes every 2+/- panels.
- Additional coats may be applied with 45-60 minutes or wait until the following day if you are beyond 90 minutes. CARPRO recommends 2 coats. You may apply additional coats if you wish.
- We do NOT recommend adding Reload on top unless you wish to do so after fully cures or in future. SiC is very slick on its own and in fact more slick than Reload.
After Tips:
- Keep surface dry for at least 3 hours after application (For best results keep dry for 24 hours).
- Gently wipe any water off the surface during the first 24 hours after application.
- Avoid detergents and chemicals for 5 days after application.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
