SummitSeal Block Paving Sealer is a solvent-borne, premium resin-based sealer and jointing sand stabiliser with exceptional effectiveness. that will provide a heavy-duty, long-lasting clear seal coating with a matt look finish.
Its penetration comes about by solvent evaporation, penetrating into the blocks and binds the particles of sand to form an elastomeric joint and protect the paver face from oil and water infiltration.
The sealer prevents moss and weed formation when applied correctly, joints should be re-sanded for optimum results.
100% UV light fade resistant, resistant to tyre plucks and resists oil stains, colour loss of the blocks and water damage.
Suitable for - commercial, public or industrial premises with heavy to extremely heavy traffic, this product is also perfect for use on residential driveways for customers that want an extra hard-wearing product.
Maintains the performance life of the pavement. Yields significant whole-life cost savings and reduces interim maintenance.USES AND SURFACE COMPATIBILITY
Suitable for use on block paving, brickwork and concrete.
COMPATIBLE PRODUCTS
Driveway Cleaner -
Oil Stain Remover -
Efflorescence Remover -SPECIAL PROPERTIES
It is easily cleaned and will withstand regular washing. Also resistant to most oils.
SPREADING RATE
- First coat: Approximately 4 square meters per litre.
- Second coat: Approximately 6 square meters per litre.
This is a rough estimate and varies depending on the condition of the driveway and the amount applied with each coat.
DRYING TIME
Under normal conditions, it is touch dry in approximately 3-4 hours.
Do not drive on the surface for 24 hours after the last coat.
APPLICATION
Brush, Roller, or Sprayer.
Sprayers will provide the best results due to there being less chance of interfering with the sanded joints.
Rollers and brushes are fine for application, be careful when going over joints for best results.We have compatible application tools on our website.
Make sure the surface is 100% dry and free from any moisture or contaminants before application. Do not apply if there is any chance of rain.STORAGE PRECAUTIONS
Store away from heat and flames. Secure the lid between uses to prevent paint hardening. Store away from frost.
THINNERS
Thinners aren't required with this product, use xylene or proprietary brush clear for cleaning.
SURFACE PREPARATION
Ensure all surfaces to be sealed are clean, dry and free from oil and grease and there are a couple of days of good weather so there is no chance of rain during application.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
