This 1.5 Gal Heavy-Duty Sprayer is equipped with VITON rubber seals and is ideal for applying our removers and coatings.
Compatible with:
- Heritage Graffiti Remover
- Bare Brick Remover
- Sensitive Surface Remover
- Vanish
- World's Best Detergent
- World's Best Graffiti Coating
- 4G Surface Guard
Not recommended for MuralShield.
After extensive trials, we have found that the EPDM seals on the SOLO Cleanline 1.5 Gal sprayer are slightly more resistant to Bare Brick Remover. However, either sprayer will work well for Bare Brick Remover, especially if you clean it after use.
- The extra-large, heavy-duty pump pressurizes the tank with far fewer strokes, making it as much as 50% more efficient than other sprayers.
- The 28" unbreakable wand with a professional shut-off valve provides extended reach.
- The automatic pressure relief valve releases excess pressure at 45 psi with external valve operation.
Please Note: The life of this sprayer will be substantially extended if you clean it out with water after use. First, empty the contents back into the container, then rinse with water. Fill the tank again with water and pump it up before releasing pressure to thoroughly rinse out the interior of the sprayer. We normally lock the sprayer in the "on" position and leave the wand hanging over the back of our truck. This will run water through the sprayer for several minutes and ensure it is thoroughly cleaned for the next use.
If you never clean out your sprayers, we recommend purchasing a spare set of VITON rubber seals, which are available for sale on this website.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
