481007

3M EC Glue Gun Heater Repair Kit

From
$35.99
Learn More
Check Store Availability

We don't have enough stock on hand.

Adding to cart… The item has been added
Added to Cart

If your 3M EC glue gun will not heat it could be a few different problems to check and see if the heater is what needs to be replaced. Turn the EC glue gun power switch on and check the electrical continuity of the heater/TCO/switch assembly. Use an ohmeter and measure across the terminals numbered 3-4 on the top terminal block labeled TB2. The measured value should be between 40-50 ohms. If the measured value is not in that range then replace the heating/TCO/switch assembly using the 3M Heater Kit part number 62-9680-9731-1.

WASHING INSTRUCTIONS:

Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.

Reviews