The non-ASME, resin casting (mold) pressure tank from C.A. Technologies comes configured with a single air pressure regulator and No pickup tube. The pressure pot is available in 2.5, 5, 10, 15 and 20 gallon sizes and is constructed of a heavy gauge steel and has wheels for maneuverability or optional stationary feet.
Dimensions:
- 5 gallon tank (inside diameter is 12.5? and inside depth is 15.5?)
Specifications:
Set-up Information: When installing quick disconnect fitting, apply an anaerobic sealant which will harden overnight without the presence of air. Cross tighten lid wing nuts with a 12" adjustable wrench to insure the lid seal is holding pressure. It is hard to provide a pot with reliefs, regulator, and ball valves without some minor air leak. To compensate for a minor air leak, keep your compressed air supply hooked up to pot during your casting process.
*(Please note that additional fittings may be needed to connect the resin casting tank to a compressor. The fittings can be sourced locally or you can reference our Fittings Kit item number AFS-1593.)
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
